4.72
Alarm systems
Camera surveillance
Intercom access systems
Black Friday Deals
JA-110I
Service explanation for JA-110I
BUS section / output PG activation indicator
This product is part of the JABLOTRON JA-100 alarm system. It provides an optical indication of the status of the system sections (armed / disarmed) or the position of the programmable outputs. The product is intended for installation by a trained technician with a valid Jablotron certificate.
Installation
1. Open the indicator cover by loosening the four snap clips using a suitable flat screwdriver, turning in the direction of the arrows.
2. Loosen the click clamp (1) and remove the plate. 
Picture: 1 – click clamp of the plate; 2 – configuration switch; 3 – red signal light of the indicator; 4 – hole to break open; 5 – BUS terminals
3. Use the switch (2) to set the number of the section that needs indication (see Tab. 1) or PG output (see Tab.2).
4. Pull the cable through the opening made (4) and fix the back wall of the indicator in the chosen location.
5. Fold back the indicator plate and connect the bus cable to the terminals (5).
Before connecting the BUS, the system must be disconnected from the power supply.
If the indicator is located outside the area to be monitored, the supply of its BUS must be isolated with a JA-110T bus isolator.
6. After turning on the system, test its operation.
7. Replace the indicator cover. 
Tab. 1 Setting for indication of a section
Tab. 2 Setting for indication of a Pg output
Comments:
- Indicator does not occupy any position in the control panel (it is not allocated in the system).
- With several connected modules with the same setting, the same indication will be given.
- Number of indicators is only limited by power consumption from the control panel. 
Image: JA-110I indicator dimensions.
Technical parameters
Power supply from the BUS of the control panel 12 V (9 ...15 V)
Standby power consumption (LED on / off) 6 mA / 3 mA
Current consumption for choice of cable 6 mA
Dimensions 62 x 36 x 27mm
Classification grade 2
according to EN 50131-1, EN 50131-3
Environment according to EN 50131-1 II. inside, general
Operating temperature range -10 to +40 °C
Further complies with EN 50130-4, CSN EN 55022
Product JA-110I is designed and manufactured in accordance with the applicable provisions: Government Decree No. 17/2003 Sb. and 616/2006 Sb., if used as intended. Original declaration of conformity can be found on www.jablotron.cz in the advice section.
Note: Although this product does not contain any harmful materials, do not dispose of it with household waste, but hand it in at the collection point designated for electronic waste.
